#include "stm32f10x.h"
//#include"stm32f10x_lib.h"
void Delay(unsigned intx);
void UART_Init(void);
int main(void)
{
while(1)
{
Delay(300000);
UART_Init(); //初始化串口
USART_SendData(USART1,0x1A); //從串口發送數據到計算機
while(USART_GetFlagStatus(USART1,USART_FLAG_TXE)==RESET);//RESET是0，等待發送完畢
//if(USART_GetFlagStatus(USART1,USART_FLAG_TC)==RESET)
GPIO_SetBits(GPIOC, GPIO_Pin_6 ); //發送完畢則點亮D1二極管
}
}
void UART_Init(void)
{
SystemInit();//配置系統時鐘
RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA | RCC_APB2Periph_GPIOB| RCC_APB2Periph_GPIOC | RCC_APB2Periph_GPIOD |RCC_APB2Periph_GPIOE |RCC_APB2Periph_USART1,ENABLE);//IO口使能設置
GPIO_InitTypeDefGPIO_InitStructure; //定義I/O口結構體
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_2 | GPIO_Pin_3;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_Out_PP;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_Init(GPIOA,&GPIO_InitStructure);
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_6 | GPIO_Pin_7;
GPIO_Init(GPIOC,&GPIO_InitStructure);
USART_InitTypeDef USART_InitStructure;//定義串口結構體
//RCC_APB2PeriphClockCmd(RCC_APB2Periph_USART1，ENABLE);//使能串口1
USART_InitStructure.USART_BaudRate=38400;
USART_InitStructure.USART_WordLength=USART_WordLength_8b;
USART_InitStructure.USART_StopBits=USART_StopBits_1;
USART_InitStructure.USART_Parity=USART_Parity_No;
USART_InitStructure.USART_HardwareFlowControl=USART_HardwareFlowControl_None;
USART_InitStructure.USART_Mode=USART_Mode_Rx |USART_Mode_Tx;
USART_Init(USART1,&USART_InitStructure);
USART_Cmd(USART1,ENABLE);
}
void Delay(unsigned intx)
{
unsigned int t;
t=x;
while(t--);
}
|
