|
|
//-----------------------------------------------
// PIC18 MCC PIC18F6622 CONFIG BITS 1=OFF
//CONFIG1H 禁止振蕩器切換，禁止故障保護時鐘，HS振蕩器
//CONFIG2L 欠壓復位電壓最大值，禁止欠壓復位，禁止上電延時
//CONFIG2H 關看門狗及喂狗時間
//CONFIG3H 使能MCLR，高功耗TIMER1，CCP2與RC1復用
//CONFIG4L 后臺調試關，擴展指令開,BOOT引導區2K，使能單電源,堆棧溢出復位
//CONFIG5L BLOCK0-3代碼不保護
//CONFIG5H EEPROM&引導區 代碼不受保護
//CONFIG6L BLOCK0-3 不受寫保護
//CONFIG6H 數據EEPROM 引導區 配置寄存器不保護
//CONFIG7L 禁止其它塊對BLOCK0-3執行表讀操作
//CONFIG7H 禁止其它塊對引導區（000000-0007FFh）執行表讀操作
//-----------------------------------------------
#pragma config IESO = OFF, FCMEN = OFF , OSC = HS
#pragma config BORV = 0 , BOREN = OFF , PWRT = OFF
#pragma config WDT = OFF, WDTPS = 128
#pragma config MCLRE = ON , LPT1OSC = ON , CCP2MX = PORTC
#pragma config DEBUG = OFF, BBSIZ = BB2K, XINST = ON , LVP = ON , STVREN = ON
#pragma config CP0 = OFF, CP1 = OFF , CP2 = OFF, CP3 = OFF
#pragma config CPD = OFF, CPB = OFF
#pragma config WRT0 = OFF, WRT1 = OFF , WRT2 = OFF, WRT3 = OFF
#pragma config WRTD = OFF, WRTB = OFF , WRTC = OFF
#pragma config EBTR0 = ON , EBTR1 = ON , EBTR2 = ON
#pragma config EBTRB = OFF
|
|
